The acid zinc plating solution has poor temperature resistance and large production consumption. Try this potassium chloride zinc plating brightener

The acid zinc plating solution has poor temperature resistance and large production consumption. Try this potassium chloride zinc plating brightener

Mon Jan 16 09:04:14 CST 2023

    Mr. Zhao is the owner of a processing factory specializing in zinc acid galvanizing of various small hardware in Jiangmen, Guangdong.Because Mr. Zhao's acid galvanizing bath is not equipped with a temperature control system, when the bath temperature is 28~32 ℃, the brightness of the coating is reduced, rough, and the adhesion is poor, and the amount of brightener is large, and the production cost is high.So Mr. Zhao wanted to find a potassium chloride zinc brightener with good temperature resistance.

    One day, Mr. Zhao saw Bigolly's potassium chloride zinc plating brightener BZ-525 while searching online, so he inquired about the performance and dosage of this brightener.After introducing the performance of this brightener, the engineer learned about Mr. Sun's production in detail, and then recommended Mr. Zhao to use this brightener BZ-525.

    This potassium chloride zinc plating brightener BZ-525 is a water-based formula with low COD, which meets the environmental requirements.The brightener has high cloud point and good temperature resistance, which can be applied to the production requirements of acid zinc plating at 20~40 ℃. Moreover, the brightener has high concentration, low consumption and low consumption, which can effectively save production costs.Mr. Zhao compared other brighteners and decided to buy two barrels of BZ-525 to try.

    Under the guidance of Bigolly engineer, Mr. Zhao used it for more than ten days. After comparison, he found that the temperature resistance of this potassium chloride zinc brightener BZ-525 was really good.During the production of 32 ℃ plating solution, the coating of the workpiece is not foggy, and the amount of brightener is very low, which is half less than the previous one, greatly reducing the production cost.So Mr. Zhao signed a cooperation agreement with Bigolly.

    Therefore, we should try this potassium chloride zinc brightener BZ-525 as soon as possible because of the poor temperature resistance and large amount of zinc plating solution in the process of zinc acid plating.If you are interested in this potassium chloride zinc brightener, please contact Bigolly customer service for free samples and detailed technical information!