Mr. Fang from Tianjin is the boss of an electroplating factory specializing in chemical nickel plating.He has 4 electroless nickel plating production lines, which can process workpieces in different fields.Recently, Mr. Fang received a connector for aircraft, and the workpiece coating needs 20 μm thickness.However, after electroless nickel plating on the workpiece, the coating is brittle and magnetic, which does not meet the customer's requirements.The additive supplier still has such problems after treating the bath for many times, so Mr. Fang wants to find a high phosphorus electroless nickel plating additive that meets the customer's requirements.
One day, Mr. Fang found Bigolly Technology while searching for "Electroless Nickel Plating Additive Manufacturers" on the Internet. After knowing Bigolly's company strength and technical service ability in detail, he asked the engineer whether there were electroless nickel plating additives that met his needs.After understanding the production situation of Mr. Fang, the engineer recommended that Mr. Fang use this high phosphorus electroless nickel plating additive Ni-811.
This high phosphorus electroless nickel plating additive Ni-811 is prepared with new R&D technology and imported raw materials.The plating solution has good stability, low brittleness of the coating, and can meet the requirements of workpiece thickness of more than 20μm.The workpiece coating has good hardness, wear resistance and corrosion resistance. The salt spray test is over 168 hours, and the coating is not magnetic, which can meet the electromagnetic shielding performance of these connectors.After consideration, Mr. Fang directly bought three barrels of electroless nickel plating additive Ni-811 to try.
Under the guidance of the engineer, half a month later, Mr. Fang reported that the deposition rate of the workpiece was 1.5 times faster than the previous additive, and the service life of the plating solution was more than twice as long.The workpiece coating has good bonding force and low brittleness. The 25μm coating did not fall off during bonding force test, and the coating has no magnetic properties, which can meet the electromagnetic shielding performance of these connectors.So Mr. Fang signed a cooperation agreement with Bigolly.
Therefore, after electroless nickel plating, if the electromagnetic shielding performance of the coating is poor, we may try this high phosphorus electroless nickel plating additive Ni-811.If you are interested in high phosphorus electroless nickel plating additives, you can contact the Bigolly customer service for free samples and detailed technical information!